3/32" Axle bearing/bushing installation and alignment tool

review
0
0
5
Your Price: $19.99
In Stock.
Part Number:151
You need to be a registered customer to order this product. Please Login to your account or click here to Register.
The 3/32" axle bearing/bushing installation and alignment tool is back with a new updated design. We've added a flange on one side of the stainless steel collet to make it easier to use with bushings. The flange allows for a little more room between the bushing/bearing install tool and your soldering iron tip.

No more guessing or worries about slightly out of line pillow blocks or bearings. You can now solder or glue your bushings and bearings in place while being held straight. This is used by many of the top builders!

The spring is soldered to two brass tubes which push the inside bearing race outward. Simply place the spring and the brass tubes in the middle of your bearings (pushing outward) and place the collars on the outside of each bearing then tighten the setscrew. 

You will receive the following pieces:
  • 4" ground jig axle
  • Stainless Steel custom spring with brass tubes pre-soldered to the sprin
  • Two stainless collars that support the outer race of the bearing keeping the bearings perpendicular to the axle

Related Items

Recently Viewed Items